Hi,
I just want to know if it is possible to simulate Kepware with PLCSim 5.4.
I tried to make an ethernet network on my PLC and use its IP adress on Kepware PLC side but it don't works.
Please help here.
Thank you very much in advance.
[?]: is possible PLCSim 5.4 Simulation with Kepware ?
-
reymond_craig
- Posts: 139
- Joined: Wed Sep 26, 2007 2:57 am
- Location: Philippines
-
negotio
- Posts: 7
- Joined: Thu Nov 06, 2008 7:06 pm
- Location: Europe
Alternative program
Unfortunatly it is not possible for other programs to connect to PLCSim. But I recently found a program called WinPLC-Engine on the MHJ website (http://www.mhj-software.com/). I think this program will do the job.