[LINK]: Service Pack 2 for Step7 5.4

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
Juli
Posts: 66
Joined: Sat Dec 10, 2005 4:01 pm

[LINK]: Service Pack 2 for Step7 5.4

Post by Juli »

CoMod
Site Admin
Posts: 3995
Joined: Thu Feb 16, 2006 3:25 pm
Location: Russia
Contact:

Post by CoMod »

SIMATIC STEP 7 Professional 2006 SR2
comprises:
STEP 7 V5.4 incl. SP2,
S7-GRAPH V5.3 incl. SP3,
S7-SCL V5.3 incl. SP2,
S7-PLCSIM V5.3 incl. SP1

http://support.automation.siemens.com/W ... n/25548597

On some computers right after installations of updating of program ALM 3 HF3 (from Step7 v5.4 SP2) can arise problems with working capacity of original and not original keys.
The reason of an error while is unknown.

Method of the decision of a problem.
1. Reload a computer.
2. Check up keys through program ALM.
3. Try to reinstall program ALM.
4. Reinstall keys.
5. Deinstall the new version of the program and install previous version ALM 3 HF1.
CoMod in Russian wrote:На некоторых компьютерах сразу после установки обновления программы ALM 3 HF3 ((из Step7 v5.4 SP2)) могут возникнуть проблемы с работоспособностью оригинальны[ и неоригинальным ключей.
Причина ошибки пока неизвестна.
Метод решения проблемы.
1. Перезагрузите компьютер.
2. Проверьте ключи через программу ALM.
3. Попробуйте переустановить программу ALM.
4. Переустановите ключи.
5. Деинсталлируйте новую версию программы и установите предыдущую версию ALM 3 HF1.
CoMod
Site Admin
Posts: 3995
Joined: Thu Feb 16, 2006 3:25 pm
Location: Russia
Contact:

Post by CoMod »

English page
Service Pack 2 for STEP 7 V5.4 and STEP 7 Professional Edition 2006
http://support.automation.siemens.com/W ... n/25602738


Service Pack 3 for S7-GRAPH V5.3
http://support.automation.siemens.com/W ... n/25479600

but link for dowload from german page
http://support.automation.siemens.com/W ... d=25675067
Post Reply