[?]: Automatic gauge control in hot rolling mills

SIMATIC S7-200/300/400, Step7, PCS7, CFC, SFC, PDM, PLCSIM,
SCL, Graph, SPS-VISU S5/S7, IBHsoftec, LOGO ...
Post Reply
mundapichi
Posts: 8
Joined: Thu Nov 09, 2006 3:04 pm
Location: Asia

[?]: Automatic gauge control in hot rolling mills

Post by mundapichi »

1. can somebody tell me if anywhere agc of hot rolling mill ( single or multistand) is commissioned using SIMATIC S7 with special function modules.
If so can anybody send me the software.

2. I am using SIMADYN D with STRUC G programming package.
Is there any conversion package available to convert STRUC G function blocks to D7-SYS system.
Post Reply