[?]: How to upload program from Panelview-plus-400 by Ethern

[hussein kamal]

hi every one
can any one help me i need to upload program from Panelview-plus-400 by Ethernet but i try to take IP from screen but i don't how and i don't have IP address for that screen and it in run and which keypad give to access to get IP

[collgl]

you can find ip in mode config.

[hussein kamal]

Dear collgl
thanks for your reply and the screen go in run mode when start so how i go to mode configuration on it
so many thanks to you

[Ryzhij]

You can use Configuration_Screen_Utility, which you can read about here or here (temporary mirror) and download an archive of it here or here (I will keep for a while).
This utility allows you to access the configuration screen panel, overriding automatic launching of the project in the panel .

[hussein kamal]

thanks many thanks to you
but if there is way to get in pv+ to see terminal view to get ip addresses and upload program like push f1or f2 while start some thing like that

[collgl]

To enter the configuration mode,for touch screen, you could touch the upper left corner and the lower right corner of the screen simultaneously at startup.

[hussein kamal]

To enter the configuration mode,for touch screen, you could touch the upper left corner and the lower right corner of the screen simultaneously at startup.

thanks man i used that away to get in pro-face touch screen i hope to tell me in pv+ 400 how i get in terminal configuration to get ip address to upload program
thanks again

[collgl]

at star-up of your PV400+, you can click the small white box when it displays in the lower left corner of the screen to enter the mode configuration.