Connecting ABB AC800F Controller To Simatic WinCC Prof

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
Eng-Hunter
Posts: 1
Joined: Sat Feb 22, 2014 8:00 am

Connecting ABB AC800F Controller To Simatic WinCC Prof

Post by Eng-Hunter » Wed Jan 22, 2020 12:31 pm

Hello Every One ...

Does any one know how to Connect a ABB AC800F Controller To WinCC SCADA System Using OPC .. ??
and if any one have a training course for the OPC ..

thanks every one ...

kukuris
Posts: 1
Joined: Tue Jul 24, 2018 5:53 am

Re: Connecting ABB AC800F Controller To Simatic WinCC Prof

Post by kukuris » Sat Feb 01, 2020 9:47 am

use modbus TCP communication (sorry AC800F support Modbus TCP)

Other solutions (additional communication modules) : below refer sites (ABB)
----------------------------------------------------------------------------------
1. PROFIBUS
2. FOUNDATION
3. MODBUS (master / slave, RTU or ASCII)
4. IEC 60870-5-101, IEC 60870-5-104
5. CAN


Refer site
------------
https://new.abb.com/control-systems/ess ... ler/ac800f
Last edited by kukuris on Sat Feb 01, 2020 10:36 am, edited 2 times in total.

Answers to FAQs
Faq & Info
Faq & Info
Posts: 84
Joined: Thu Oct 13, 2005 6:42 pm
Location: Frequently Asked Questions – Часто Задаваемые Вопросы

Re: Connecting ABB AC800F Controller To Simatic WinCC Prof

Post by Answers to FAQs » Sat Feb 01, 2020 10:28 am

you can use s7-1211+cb485 as Modbus gateway

Post Reply