can't view or save the program

RSLinx, RSLogix, RSView, LogixPro ...
Post Reply
kevinCN
Posts: 3
Joined: Wed Dec 13, 2017 8:26 am

can't view or save the program

Post by kevinCN » Wed Dec 13, 2017 8:55 am

i cannot upload or modify at rslogix 500 due to s:1/14 access deny bit is active,at the same time,data table protection was enable,in this case,how to upload the plc program

psgama
Posts: 78
Joined: Thu Aug 08, 2013 6:00 pm

Re: can't view or save the program

Post by psgama » Fri Dec 15, 2017 10:24 pm

What version RSlogix 500 you use?

kevinCN
Posts: 3
Joined: Wed Dec 13, 2017 8:26 am

Re: can't view or save the program

Post by kevinCN » Sat Dec 16, 2017 12:05 am

psgama wrote:What version RSlogix 500 you use?
the version rslogix 500 is v10,thiank you

Post Reply