Request: Dox10 3.4 for Sattcon 200 Series from ABB

другие контроллеры
Post Reply
Elahe
Posts: 20
Joined: Thu May 28, 2009 6:02 am

Request: Dox10 3.4 for Sattcon 200 Series from ABB

Post by Elahe » Thu May 28, 2009 6:10 am

Hi Friends
I am working on Sattcon 200 Series from ABB .
anyone can share me dox10 with new vesion such as 3.4 ?
Thanks

drzewiec
Posts: 3
Joined: Sat Feb 08, 2014 5:42 pm

Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB

Post by drzewiec » Tue Mar 18, 2014 8:25 pm

Good day,

I am also looking DOX10 3.4-0 for a long time, could somebody share it?

WBR, Drzewiec

Carlos
Posts: 105
Joined: Sat Apr 30, 2011 7:08 pm

Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB

Post by Carlos » Tue Mar 18, 2014 10:26 pm

A few years ago I tried to connect with Sattcon controller but without success.

http://www.cnczone.com/forums/general-c ... -need.html
password ADM is dox10

serial cable
2-3
3-2
5-7

other information by Sattcon:
....... your cable configuration is correct. you can power off and hold shift button and then power up, this will restart but you must have backup and cable to upload backup after restart.
We also convert any SATTCON PLC to AC800M (ABB) or S7 (siemens)...........


Carlos

Turkey4VM
Posts: 21
Joined: Tue Mar 18, 2014 3:54 pm

Re: Request: Dox10 3.4 for Sattcon 200 Series from ABB

Post by Turkey4VM » Wed Mar 19, 2014 3:19 pm

Cable for sattcon 200: I did it by my self. Works fine. But it is need a native com port in your pc, any adapters usb-to-com doesn't work.
Image

Post Reply