[?]: software instead quick designer to program proface hmi

Прочие SCADA: iFix, InTouch, Citect, ...
Post Reply
Posts: 98
Joined: Sun Dec 30, 2007 8:03 am
Location: Mexico

[?]: software instead quick designer to program proface hmi

Post by asteroidehk » Thu May 08, 2008 3:56 pm

Hello Friends

QuickDesigner export projects with .prj extension.

Can I open this .prj project with another software? Wich One?

Also, i have an pro-face hmi QPGCTDE0000 but, firmware it´s in chinese or japanese. :shock:
I want to change to english because is a big problem to undestand when I go to hmi setup.

Quickdesigner can´t change firmware, wich software could do that?

Thanks in advance.

Posts: 38
Joined: Fri May 02, 2008 4:41 am
Location: Mexico

Post by enrique_gf » Sat Sep 06, 2008 8:27 pm

Hi have you tried this software?

http://plc.net.ru/viewtopic.php?t=5623& ... ht=proface


Posts: 107
Joined: Fri Aug 11, 2006 6:16 pm
Location: Russia, Komi

Post by indian » Sun Sep 07, 2008 6:01 pm

Recently I worked around it because I had been forced to find out a replacement for discontinued QPK panels. I found out that "Proficy View" software is uploading QD's projects. (or, it is just make a porting?) Also new one panel is needed, anything like this - IC754VSI06. So, it is very costly update.

Post Reply