Page 1 of 1

Pro Panel help

Posted: Tue Sep 26, 2017 10:37 pm
by luuxiii
I place a components from 3D Mounting layout (eg. A999)
after I place components, the new A999 shows up with red dot infront.
Image

Why does this happend ?

Re: Pro Panel help

Posted: Wed Oct 25, 2017 8:59 am
by lin2m3
Be sure you have unique DT on every part and Ful DT field filled. If your part has more sub-parts, either you unite them or define them with a unique DT(Full DT). Red dot shows you have an error in the project from the view point of Propanel.

Re: Pro Panel help

Posted: Thu Nov 09, 2017 12:21 am
by luuxiii
lin2m3 wrote:Be sure you have unique DT on every part and Ful DT field filled. If your part has more sub-parts, either you unite them or define them with a unique DT(Full DT). Red dot shows you have an error in the project from the view point of Propanel.
Thank you very much. I'll take a look in this matter :)