[?]: test configuration to check Modbus PTP module
Posted: Fri May 30, 2008 11:02 am
I need test configuration to check Modbus PTP module.
I have CP341 and host link gauge system module (as i suppose it run in ASCI modbus RTU mode)
How can I test this system in short time?
(I only need to test CP341 module)
Thanks for any information about it.
I have CP341 and host link gauge system module (as i suppose it run in ASCI modbus RTU mode)
How can I test this system in short time?
(I only need to test CP341 module)
Thanks for any information about it.