[?+]: problem in Protool 6 for starting a new PC project

joopiter · Post by **joopiter** » Wed Jan 02, 2008 10:02 am

hello friends
i have a problem with protool 6+sp3
i want to start a new project for a standard pc,when i open a new project i can see all kinds of OPs TPs,MPs but i can not see PC,what should i do?

Dfcz · Post by **Dfcz** » Thu Jan 03, 2008 7:47 am

You use Protool is not Professional Edition mode.
Use search.

After installation Start>Run> enter REGEDIT and replace Registry key
[HKEY_LOCAL_MACHINE\SOFTWARE\Siemens\PROTOOL\6.0]

Protool Pro
P06000000F:02354=618>>;=;:T>>71;:4>K

Before and After Regedit correction

votuandktd · Post by **votuandktd** » Thu Jan 03, 2008 7:51 am

You would use WinCC Flexible
Good luck,

Dreamer76 · Post by **Dreamer76** » Fri Jan 04, 2008 4:26 am

votuandktd wrote:You would use WinCC Flexible
Good luck,

you cant project older panels with win cc flex. so sometimes you must use protool. maybe protool is a bit difficult to use.win cc flex is easier.

ciao
Dreamer76

votuandktd · Post by **votuandktd** » Fri Jan 04, 2008 6:49 am

Dreamer76 wrote:
you cant project older panels with win cc flex. so sometimes you must use protool. maybe protool is a bit difficult to use.win cc flex is easier.

ciao
Dreamer76

You right! But the question is using Protool in the standard PC.

Best regards,

joopiter · Post by **joopiter** » Sat Jan 05, 2008 10:45 am

Dear Dfcz thanks a lot for your help,i did what you said and my problem solved,really thanks a lot

Dreamer76 · Post by **Dreamer76** » Sat Jan 05, 2008 1:30 pm

votuandktd wrote:You right! But the question is using Protool in the standard PC.
Best regards,

i think yes

ciao
Dreamer76