[?]: WinCC Flex 2008 - Order of installation?

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
nashama
Posts: 50
Joined: Thu Apr 21, 2011 9:37 am

[?]: WinCC Flex 2008 - Order of installation?

Post by nashama » Thu Sep 08, 2011 12:40 pm

Dear All,

From the below list , What should be the order of installation after installing WinCC Flex 2008?


1) Wincc Flex 2008_SP2


2) Wincc Flex 2008_SP2_UPD 13


3) Wincc Flex 2008_HF3


And one more thing - I remember when I was having WinCC Flex 2005, I found my RAM memory is considerably utilized when WinCC Flex 2005 is in use.

Any specific reasons? .......... And shall I expect the same for WinCC Flex 2008 as well?

Plz advice.

Regards

Umencho
Posts: 508
Joined: Mon Jul 16, 2007 12:28 pm
Location: Europe

Re: WinCC Flex 2008 - Order of installation?

Post by Umencho » Thu Sep 08, 2011 2:23 pm

I assumed you have only WinCC FLex 2008. So, start with it. Then SP2. But take in mind
The Download of the service pack 2 requires an installed WinCC flexible 2008 or WinCC flexible 2008 SP1. It is not possible to install WinCC flexible with the download under Windows 7. For the installation under Windows 7 you need the the above-mentioned WinCC flexible DVD, which can be ordered from your Siemens contact person.
Then Update 13 for WinCC flexible 2008 Service Pack 2 . From the name is clear why is that.
You don't need Hotfix as is included in SP.
About the memory, I don't know how many GByte you have but there is need 2GB as recommendation. For me, multiplay this by 2 and 4 GB like a final result is "acceptable".

Post Reply