[?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
Homeroid_BL
Posts: 259
Joined: Fri Apr 03, 2009 3:24 pm
Location: Bosnia and Herzegovina

[?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by Homeroid_BL » Tue May 28, 2013 11:25 pm

Hi all!

Suddenly, I can not connect any PC HMI application to S7-1200 (6ES7 214-1AG31-0XB0) via Ethernet.
Both HMIs, WinCC Advanced V11 SP2, and WinCC Flexible 2008 SP2
reports an error:
"missing user rights to write into registry"
Flex RunTime Error
Show
Image
WinCC TIA Error
Show
Image
All the time PLC is online, visible, working fine.
TIA Prog OnLine & WinCC TIA Error
Show
Image
Someone knows what is going on?

dls.dls
Posts: 17
Joined: Wed Feb 28, 2007 11:57 am
Location: France

Re: [?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by dls.dls » Wed May 29, 2013 7:15 pm

With the fault number (1400XX) you will mabe found any détails in the documentation.

Good luke!

Homeroid_BL
Posts: 259
Joined: Fri Apr 03, 2009 3:24 pm
Location: Bosnia and Herzegovina

Re: [?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by Homeroid_BL » Thu May 30, 2013 9:16 am

Nice joke, dls.dls :) Since documentation tells that "my station is not connected", so i should "check cable and wiring" :)

sania
Site Admin
Posts: 1372
Joined: Sat Aug 13, 2005 6:15 am
Contact:

Re: [?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by sania » Sat Jun 01, 2013 6:44 pm

set your pg/pc interface as tcp/ip - your net card

Homeroid_BL
Posts: 259
Joined: Fri Apr 03, 2009 3:24 pm
Location: Bosnia and Herzegovina

Re: [?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by Homeroid_BL » Sun Jun 02, 2013 3:29 pm

It was set to TCP/IP, bu access point was MicroWin, not S7ONLINE.
Changing access point to S7ONLINE, problem was solved.

But, it menas that in TIA Portal:
-connection to PLC work regardles of PG/PC interface set (not relevant)
-connection to HMI considers PG/PC interface settings?????

Anywy, error description as "missing user rights" did not help me solving problem, it's just confusing description.

Sania, thanks!

sania
Site Admin
Posts: 1372
Joined: Sat Aug 13, 2005 6:15 am
Contact:

Re: [?]: WinCC Advanced/Flexible "MISSING USER RIGHTS..."?

Post by sania » Mon Jun 03, 2013 7:17 am

Homeroid_BL wrote:But, it menas that in TIA Portal:
-connection to PLC work regardles of PG/PC interface set (not relevant)
-connection to HMI considers PG/PC interface settings?????
yes it is

Post Reply