[?]: wincc flexible 2008 sp3

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
daiphongsk
Posts: 11
Joined: Wed Aug 18, 2010 12:47 pm

[?]: wincc flexible 2008 sp3

Post by daiphongsk » Tue Jul 17, 2012 4:06 am

Hi all!
I have installed wincc flexible 2008 sp3 and i used Simatic_EKB_Install_2011_05_22 to crack wincc, then i started wincc, in start page i click create an empty project but it's not run. I see in Simatic_EKB_Install_2011_05_22, it support to crack wincc flexible 2008 sp3. Can you tell me how to crack wincc flexible 2008 sp3.
Thanks you so much!
Top
sania
Site Admin
Posts: 1371
Joined: Sat Aug 13, 2005 6:15 am
Contact:
Contact sania

Re: wincc flexible 2008 sp3

Post by sania » Tue Jul 17, 2012 5:37 am

daiphongsk wrote:i click create an empty project but it's not run.
it`s your installation problem,not Simatic_EKB_Install

try Demo
http://support.automation.siemens.com/W ... n/22900091
Top
Post Reply

Return to “SIMATIC HMI”