I know what I must check "WinCC -> PC Adapter" in Set PG/PC Interface -> Access Point of the Application.
I cann't change it in PG/PC Interface((((((((((((((
but in project SCADA I can see:
Can You help me?
[?]: connect CPU313C and WinCC V11 with use PC adapter
-
Etherlord
- Posts: 2
- Joined: Thu Jun 30, 2011 6:46 pm
[?]: connect CPU313C and WinCC V11 with use PC adapter
on computer setup Step7 5.5 and WinCC professional v11.
I know what I must check "WinCC -> PC Adapter" in Set PG/PC Interface -> Access Point of the Application.
I cann't change it in PG/PC Interface((((((((((((((
but in project SCADA I can see:
Can You help me?
I know what I must check "WinCC -> PC Adapter" in Set PG/PC Interface -> Access Point of the Application.
I cann't change it in PG/PC Interface((((((((((((((
but in project SCADA I can see:
Can You help me?
-
sania
- Site Admin
- Posts: 1371
- Joined: Sat Aug 13, 2005 6:15 am
Re: connect CPU313C and WinCC V11 with use PC adapter
go to control panel -> set pg/pc interface & you can change access point
-
Homeroid_BL
- Posts: 259
- Joined: Fri Apr 03, 2009 3:24 pm
- Location: Bosnia and Herzegovina
Re: [?]: connect CPU313C and WinCC V11 with use PC adapter
Etherlord,
you can not change adapter while in use.
you can not change adapter while in use.