PLCforum.uz.ua

Posted: **Sat Jan 15, 2011 10:54 am**

Hi all,
Is it possible to covert *.PDZ file ( HMI back up on MMC) to *.hmi ( Wincc flex configuration) .
B'coz i have backup in the form of PDZ and i want *.hmi file for debugging.

Thanks

Amit

Posted: **Sat Jan 15, 2011 11:05 am**

In this time it impossible.

Posted: **Fri Jun 15, 2018 9:54 pm**

http://support.automation.siemens.com/W ... n/21907703
chapter 1.1:

".... SAVEDATA.PDZ .... store not only the compiled project file, but also the compressed source database of the project.
In this way, it is possible to restore the complete project from your operator panel at any time. This restoring is not only for the compiled project file, but also for the source database (*.hmi) that is required for the Engineering."

PLCforum.uz.ua

[?]: wincc flex PDZ file to HMI conversion

[?]: wincc flex PDZ file to HMI conversion

Re: [?]: wincc flex PDZ file to HMI conversion

Re: [?]: wincc flex PDZ file to HMI conversion