[?]: wincc flex PDZ file to HMI conversion

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
amit
Posts: 52
Joined: Thu Apr 23, 2009 2:12 pm
Location: India

[?]: wincc flex PDZ file to HMI conversion

Post by amit » Sat Jan 15, 2011 10:54 am

Hi all,
Is it possible to covert *.PDZ file ( HMI back up on MMC) to *.hmi ( Wincc flex configuration) .
B'coz i have backup in the form of PDZ and i want *.hmi file for debugging.

Thanks

Amit

CoMod
Site Admin
Posts: 3549
Joined: Thu Feb 16, 2006 3:25 pm
Location: Russia
Contact:

Re: [?]: wincc flex PDZ file to HMI conversion

Post by CoMod » Sat Jan 15, 2011 11:05 am

In this time it impossible. (h)

sanyisz
Posts: 1
Joined: Mon Sep 16, 2013 8:03 pm

Re: [?]: wincc flex PDZ file to HMI conversion

Post by sanyisz » Fri Jun 15, 2018 9:54 pm

http://support.automation.siemens.com/W ... n/21907703
chapter 1.1:
".... SAVEDATA.PDZ .... store not only the compiled project file, but also the compressed source database of the project.
In this way, it is possible to restore the complete project from your operator panel at any time. This restoring is not only for the compiled project file, but also for the source database (*.hmi) that is required for the Engineering."

Post Reply