[?]: OP 17 Password

[mazdak]

Hi Friends
I have an OP17 (6AV3 617-1JC20-0AX1) that I have no pass level 9 for it.
Is there any possibility to remove or showing this paas?
The configuration back-up is no available. so I cannot reset the configuration.
Can u suggest me a way that I could upload the configuration in PG and see it via
Protool without need to know the password?
Sincerely
Mazdak

[ppp]

1. Power OP17 off
2. Press "Esc"+"Up" and power OP17 on.
OP17 in mode "Transfer"
3. Use program Prosave make Backup OP17.
4. Password detect use viewtopic.php?f=4&t=8598

[mazdak]

Dear PPP
I followed your Instructions to put the OP17 in transfer mode and get the back-up file ".psr"
Then I used the Prosave Decoder to generate "result.txt" and it shows the pass as :00000100 (I guess it should be default pass)
Now, I have 2 questions:
1- Which pass level is this? (I've seen in Op17 manual that some actions need Pass level 9 and some the lower levels)
2- How can I get the source configuration of OP17 that could be seen or modified via protool ?
Sincerely
Mazdak

[ppp]

Possible is and other passwords for other levels.
See file decoded.txt in WinHex.

[mazdak]

Dear PPP
I open the "decoded.txt" with WinHex. But I didnot see pass levels
and what about the first questin. How can I get the source config of OP 17 that can edit it via protool?
Mazdak

[mazdak]

all friens
can any one help?
How can I Upload the configuration from OP17?
tha Back-UP file ".psr" that is uploaded by Prosave, is not usefull for me.
I need to change the configuration and download it to OP again!
Is there any solution?
Sincerely
Mazdak

[Scarch]

No way, you need the original file, the psr is used as a backup only. The decoder is useful to know the tags, in case you want to use another operator panel. Password 100 is the original one.