[?]: Why WinCC Flexible 2008 doesn't support TP-178..?

ProTool, WinCC flexible, WinCC, PP/OP/TP/TD/MP
Post Reply
hand_drake
Posts: 52
Joined: Thu Jun 26, 2008 1:40 am
Location: Indonesia

[?]: Why WinCC Flexible 2008 doesn't support TP-178..?

Post by hand_drake » Fri Feb 27, 2009 9:23 am

Hello....

Why WinCC Flexible 2008 doesn't support TP-178..? :shock:

TP178, 5,7", STN. With 6 keys.
P.N: 6AV6640-0DA11-0AX0.


I have install the HF-3, but still the HMI is not shows up when selecting device in WinCC Flexible 2008...?

Is there anything that I miss? :(

Thank you.

centipede
Posts: 59
Joined: Mon Feb 05, 2007 1:24 pm
Location: Europe

Post by centipede » Fri Feb 27, 2009 11:24 am

Only WinCC flex 2004 SP1 Chinese Version supports this panel.

hand_drake
Posts: 52
Joined: Thu Jun 26, 2008 1:40 am
Location: Indonesia

Post by hand_drake » Fri Mar 06, 2009 3:45 am

And...

Is there any link to get WinnCC 2004 SP1 Chinese version..? :cry:

Will be much appriciated for it. :lol:

Thank you.

xf2000
Posts: 27
Joined: Tue Sep 04, 2007 3:42 pm
Location: China

Post by xf2000 » Fri Mar 06, 2009 12:25 pm

WinCC flex 2008 Chinese Version supports this panel

hand_drake
Posts: 52
Joined: Thu Jun 26, 2008 1:40 am
Location: Indonesia

Post by hand_drake » Wed Mar 11, 2009 2:07 am

So, where i can get this WinCC 2008 Chinese version..?

Is it in the "Annoucement section" for WinCC 2008..?

Thank's.

xf2000
Posts: 27
Joined: Tue Sep 04, 2007 3:42 pm
Location: China

Post by xf2000 » Wed Mar 11, 2009 11:13 am

yes
:D :D

Post Reply