|Urgent communication between Schneider m340 and honeywell
|Page 1 of 1|
|Author:||aacmpy [ Mon Apr 16, 2018 11:56 am ]|
|Post subject:||Urgent communication between Schneider m340 and honeywell|
we work on a water station using plc schneider M340 and we should make a communication with a dcs honeywell , this dcs should read a variables from my plc i have a ethernet module BMX NOE 0.100
i put the ip adress but the dcs show that the variables are not online
|Author:||SE_support [ Mon Apr 16, 2018 5:52 pm ]|
|Post subject:||Re: Urgent communication between Schneider m340 and honeywel|
on M340 side you can only setup the IP-address and %MWi variable addresses.
So, if communication doesn't work, then check the IP and %MWi addresses.
|Page 1 of 1||All times are UTC + 3 hours|
|Powered by phpBB® Forum Software © phpBB Group