[?]: modicon CRP81100 transition to prosoft PTQ-PDPMV1

xz739 · Post by **xz739** » Thu Jul 30, 2009 1:01 am

Hi,I have some questions about Schneider modicon profibus module 140crp81100 transition to prosoft profibus module ptq-pdpmv1,would you give me some help?
Here is the hardware and software information:
Hardware:modicon cpu 43412a with profibus master crp81100 and 16 slaver SSD servo controller 635/k der;
Software:concept 2.6,PCB 2.0;

And the question is:

2.Do I need to create a new concept program or upload it from the plc?

3.How to deal with the datatype “figure”,”status”,”fahre”(I think was imported from sycon file) in the original concept program?

4.The original input/output start register data inreference was 300100 and 400100,so what’s the start input/output register with no mailbox messaging and no slave diagnostics?
5.Is there any other notes in the transition process?

thanks

RomanR · Post by **RomanR** » Thu Jul 30, 2009 4:46 am

hi xz739

2). you can upload program from plc if plc exist uplod informatin,any way this program witch out profibus configuration
3). yes im think is from syscon program(not in concept)
4).crp81100 work witch protokol DP0 ,(witch out statys of moduls)
5) dont work in this card :)

xz739 · Post by **xz739** » Fri Jul 31, 2009 12:59 am

RomanR wrote:hi xz739

2). you can upload program from plc if plc exist uplod informatin,any way this program witch out profibus configuration
3). yes im think is from syscon program(not in concept)
4).crp81100 work witch protokol DP0 ,(witch out statys of moduls)
5) dont work in this card

hi, romanr, thanks
but what's your meaning of

"5) dont work in this card"