[?]: LOGO!PC Cable pinout ?

Questions about Siemens & Analog Siemens hardware.
Software & hardware exchanger
Post Reply
Draganbap
Posts: 4
Joined: Wed Feb 20, 2008 12:43 pm
Location: Serbia

[?]: LOGO!PC Cable pinout ?

Post by Draganbap » Thu Sep 11, 2008 8:26 am

Does any have logo pc cable pinout ?

vlad2006gr
Posts: 1032
Joined: Tue Nov 20, 2007 7:08 pm
Location: Belarus

Post by vlad2006gr » Mon Sep 15, 2008 8:53 am

LOGO unit is upright:
starting upper left pin as #1 (not labelled using convention)opposite side is #6, key is on right side of connector.
1-TTL in Rx Serial
2-Gnd
3-5 volts
4-SDA for card
5-SCL for card
6-TTL out Tx Serial

You will need TTL<->RS232 converter (ie MAX202) powered by pin 3 of LOGO.
Link_is_Dead :(/s ... go_pcb.zip
Baud rate is 9600, 8bit, even HEX char.

Post Reply