plcforum.uz.ua

International PLC Forum
It is currently Thu Nov 23, 2017 2:42 am

All times are UTC + 3 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Siemens PG710 Plus
PostPosted: Thu May 19, 2016 9:57 am 

Joined: Tue May 17, 2016 4:57 pm
Posts: 3
Hi everybody, this is my first post in the forum.

A friend of mine has given me a PG710 Plus which had a hard drive crash and it was not booting at all and also floppy disks are lost, I have found a hard disk and installed dos 6.22 and STEP5 7.23 on the new hard disk, unfortunately when I run STEP5.exe in S5_SYS folder because of low RAM it can not run, gives No HIMEM.SYS or not enough XMS memory error, I tested on a virtual machine and you can run STEP5 7.23 with 8 MB of RAM, as you know PG has 2 30pin SIMM and because these are really old RAM modules I can not find RAM for it, wanted to know whether anybody can help me so that I got it up and running.

My current PG has 640kB system memory and 1024kB extnded memory, want to know what was the original DOS and STEP5 version available on PG710 Plus?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 3 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by International PLCforum® Forum Software © PLCforum
Mobile version