[?]: install WinAC RTX inside VMware
Page 1 of 1

Author:  genesx [ Sat Oct 05, 2013 1:55 pm ]
Post subject:  [?]: install WinAC RTX inside VMware

HI does anyone know how to install WinAC RTX inside VMware, I tried several time but I get the message CPU not connected, Thanks

Author:  kriztof [ Sun Oct 06, 2013 11:44 am ]
Post subject:  Re: [?]: install WinAC RTX inside VMware

I tried to test WinAC inside VirtualBox. It is terribly slow, impossible to work. I think real time system is to much for virtual machine system.

Author:  obi1987 [ Mon Oct 07, 2013 3:19 pm ]
Post subject:  Re: [?]: install WinAC RTX inside VMware

Well..I have also face some strage error while working on it.I was tested it on VirtualBox.....then I install Virtual PC and its works on it...

Author:  Hans24 [ Tue Aug 02, 2016 9:50 am ]
Post subject:  Re: [?]: install WinAC RTX inside VMware


found this some time ago and it worked!

1.Create VM at hardware compatibility 9 Version. (1 processor with 2 cores , 1 Ethernet Bridged Network Adapter)

2.In Vmware 9 VMX file You must add this lines (very important):

ethernet0.virtualDev = "e1000e"

3.Copy into VM folder file from attachment (ROM FILE).

4.Install WINAC RTX 2010 on OS

5.In station configuration Add in slot IF1 IE General card . If You prompted to install drivers from RTX then accept this. From Guest OS this card was removed. Its normal don,t panic .

6.Then From Step7 set IP addresfrom Menu --->PLC---->Edit Ethernet Node.

7. Load program and use Fully virtualized WINAC.

If You Have some problems To set IP from Edit Ethernet Node from STEP7 then You can retrive config from WLD file added into attachment. IP addres is

The files and the original posts at siemens plc forum is here:

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group