XINJE DS2-41P5-AS

привода и частотники
Post Reply
RasaPA
Posts: 1
Joined: Sat Aug 07, 2021 2:29 pm

XINJE DS2-41P5-AS

Post by RasaPA » Sat Aug 07, 2021 2:42 pm

Hi,

Does anybody know how to reset feedback or current accumulated pulses on this driver?
I connected this driver with FATEK PLC through MODBUS and what I want is to do some referencing on first start up.I send signal on SPD-A it start to go toward reference senzor and stops,go in oposite direction and than stops when it leaves sensor, like it should do.That is all OK,but now,I don`t know how to reset values to take that new position like 0 (zero).

All the best,Rasa.

Post Reply