plcforum.uz.ua
http://plcforum.uz.ua/

TUTORIAL FOR SINAMICS START DRIVE
http://plcforum.uz.ua/viewtopic.php?f=16&t=25707
Page 1 of 1

Author:  jokfem2016 [ Thu Dec 14, 2017 4:48 pm ]
Post subject:  TUTORIAL FOR SINAMICS START DRIVE

Dear all, i am new to sinamics start drive but i have a passion to have basic knowledge on how to program with start drive. I am using TIA PORTAL V13 SP1. Please, i will appreciate any tutorial that can guide me as a beginner from any of the seniors in the house.
Thanks in advance!!!

Regards,
Femi

Author:  CoMod [ Fri Dec 15, 2017 9:26 pm ]
Post subject:  Re: TUTORIAL FOR SINAMICS START DRIVE

Set adress for Status Word
Image

Set adress for Control Word
Image

Direct write Control Word and direct read Status Word
Image

Author:  jokfem2016 [ Sat Dec 16, 2017 11:38 am ]
Post subject:  Re: TUTORIAL FOR SINAMICS START DRIVE

CoMod wrote:
Set adress for Status Word
Image

Set adress for Control Word
Image

Direct write Control Word and direct read Status Word
Image



(tyou) (tyou) .

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/