two phase stepper motor does not complete it steps

привода и частотники
Post Reply
sukhoi
Posts: 38
Joined: Thu Nov 17, 2011 11:26 am

two phase stepper motor does not complete it steps

Post by sukhoi » Mon Sep 26, 2016 10:30 am

hello
i'am controling a stepper motor(1.8°/step) with a drive that uses pulses to control the steps but when i send my pulses(200) from s7-200 the first round does not complete ? i'am sure that my pulses are 200 pulse could the bearing cause this lack?

vakhramov
Posts: 17
Joined: Fri Apr 12, 2013 2:53 pm

Re: two phase stepper motor does not complete it steps

Post by vakhramov » Mon Dec 19, 2016 6:49 pm

You should read manual for your drive and for a motor. Seems that you send pulses to drive too fast (or small pauses between pulses).

Post Reply