plcforum.uz.ua
http://plcforum.uz.ua/

two phase stepper motor does not complete it steps
http://plcforum.uz.ua/viewtopic.php?f=16&t=24479
Page 1 of 1

Author:  sukhoi [ Mon Sep 26, 2016 1:30 pm ]
Post subject:  two phase stepper motor does not complete it steps

hello
i'am controling a stepper motor(1.8°/step) with a drive that uses pulses to control the steps but when i send my pulses(200) from s7-200 the first round does not complete ? i'am sure that my pulses are 200 pulse could the bearing cause this lack?

Author:  vakhramov [ Mon Dec 19, 2016 9:49 pm ]
Post subject:  Re: two phase stepper motor does not complete it steps

You should read manual for your drive and for a motor. Seems that you send pulses to drive too fast (or small pauses between pulses).

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/