Page 1 of 1

two phase stepper motor does not complete it steps

Posted: Mon Sep 26, 2016 10:30 am
by sukhoi
hello
i'am controling a stepper motor(1.8°/step) with a drive that uses pulses to control the steps but when i send my pulses(200) from s7-200 the first round does not complete ? i'am sure that my pulses are 200 pulse could the bearing cause this lack?

Re: two phase stepper motor does not complete it steps

Posted: Mon Dec 19, 2016 6:49 pm
by vakhramov
You should read manual for your drive and for a motor. Seems that you send pulses to drive too fast (or small pauses between pulses).