two phase stepper motor does not complete it steps
Posted: Mon Sep 26, 2016 10:30 am
hello
i'am controling a stepper motor(1.8°/step) with a drive that uses pulses to control the steps but when i send my pulses(200) from s7-200 the first round does not complete ? i'am sure that my pulses are 200 pulse could the bearing cause this lack?
i'am controling a stepper motor(1.8°/step) with a drive that uses pulses to control the steps but when i send my pulses(200) from s7-200 the first round does not complete ? i'am sure that my pulses are 200 pulse could the bearing cause this lack?