ABB ACS850 connect with other Devices via RS485 Onboard

привода и частотники
Post Reply
cuongvcs
Posts: 148
Joined: Fri May 23, 2008 4:00 pm
Location: Vietnam

ABB ACS850 connect with other Devices via RS485 Onboard

Post by cuongvcs » Mon Jan 26, 2015 4:14 am

Dear All,.
I has some problem with connect ABB ACS 850-04-240 Driver with compressor controller using RS485 communication. I use terminal XD2D on board for connect with controller. and the VFD ABB will running with data transfer from controller.
Could you please send me the diagram and setting on ABB ACS850 VFD ?or guide me to fix this problem.
Many thanks. (h) (h) (h) (h)

gary_angel
Posts: 7
Joined: Thu Aug 07, 2014 10:09 am

Re: ABB ACS850 connect with other Devices via RS485 Onboard

Post by gary_angel » Mon Jan 26, 2015 8:25 am

According to programming manual terminals XD2D is just for Drive-Drive connection, not for Drive-PLC.

cuongvcs
Posts: 148
Joined: Fri May 23, 2008 4:00 pm
Location: Vietnam

Re: ABB ACS850 connect with other Devices via RS485 Onboard

Post by cuongvcs » Tue Jan 27, 2015 1:58 am

gary_angel wrote:According to programming manual terminals XD2D is just for Drive-Drive connection, not for Drive-PLC.
Dear Friend,
it Only connect with other controller ( Compressor controller) via RS485 ( 3-wire ), and the ABB driver will be run follow with speed request from controller transfer to ABB driver. Not with PLC.
Please advise me.
Regards.

gary_angel
Posts: 7
Joined: Thu Aug 07, 2014 10:09 am

Re: ABB ACS850 connect with other Devices via RS485 Onboard

Post by gary_angel » Thu Feb 05, 2015 11:42 am

It doesn't matter what you connect to this port, unless it's ABB drive.

Post Reply