Danfoss VLT 5000 crane

привода и частотники
Post Reply
omar zedan
Posts: 236
Joined: Sat Oct 22, 2011 7:12 am

Danfoss VLT 5000 crane

Post by omar zedan » Wed Nov 26, 2014 8:49 pm

Dear All
I have Danfoss VLT 5000 crane driver when I operate it the ALARM[44] (Encoder fault) (Alarm LED flashing red) occurred but I didnot use encoder therefore:-
I goto parameter 650 and change protection level to (Level 1: Commissioning)by entering 110775 as a password, then I tried to change parameter 100 to (SPEED OPEN LOOP) but I can not even when parameter 18 is set to (NOT LOCKED)
what can I do to
1- Reset alarm or cancel it?
2- Change parameter 100 to (SPEED OPEN LOOP)?
Thanks

Ramomkosta
Posts: 39
Joined: Thu Nov 27, 2014 8:52 pm

Re: Danfoss VLT 5000 crane

Post by Ramomkosta » Fri Jan 09, 2015 11:13 am

omar zedan wrote:Dear All
I have Danfoss VLT 5000 crane driver when I operate it the ALARM[44] (Encoder fault) (Alarm LED flashing red) occurred but I didnot use encoder therefore:-
I goto parameter 650 and change protection level to (Level 1: Commissioning)by entering 110775 as a password, then I tried to change parameter 100 to (SPEED OPEN LOOP) but I can not even when parameter 18 is set to (NOT LOCKED)
what can I do to
1- Reset alarm or cancel it?
2- Change parameter 100 to (SPEED OPEN LOOP)?
Thanks
Hello Omar zedan.
Maybe you can't change the parameter cause is in operation.
Well,try to make a connection whith software and changed by there.


(read)

omar zedan
Posts: 236
Joined: Sat Oct 22, 2011 7:12 am

Re: Danfoss VLT 5000 crane

Post by omar zedan » Fri Jan 16, 2015 1:15 pm

Dear Ramomkosta
I can not connect it with software (I use usb to RS485 adapter) and used the software MCT 10 but when I try to connect error message appear (you can not connect this drive with this software "or somthing like this")
Thanks

Tripe
Posts: 5
Joined: Sat Aug 21, 2021 8:26 pm

Re: Danfoss VLT 5000 crane

Post by Tripe » Sun Oct 24, 2021 9:19 pm

У меня такая же проблема Danfoss vlt500 crane, ввожу в 650 параметре пароль 110775, но параметр 100 не редактируется.
Пробовал подключаться через mct10 , там такая же проблема параметр не меняется.
Может есть у кого решение как перевести данный тип плат в Open Loop?

Post Reply