[?]: The ControlNet Gateway problem

различные датчики, расходометры ...
Post Reply
Ryzhij
Posts: 406
Joined: Mon Mar 31, 2008 11:29 am
Location: Ryazan, Russia

[?]: The ControlNet Gateway problem

Post by Ryzhij » Sat Jul 16, 2011 7:35 pm

Colleagues, help me!

The situation is as follows:
On the Rackbus RS-485 hang 10 mass flowmeters E+H Promass 63.
Communicate with them on a ControlNet network via a garland
of modules E+H ZA377 -> ZA672 -> FXA675

The controller stopped seeing ZA377, the other two groups Flex-s, are seen hanging on ControlNet and functioning normally.

Replacement of modules from Endress+Hauser have failed.
ControlNet cable tested switching over to another node on the network - a cable is not defective. (h)
Experience with the Rackbus RS-485 and the modules of the E+H I lack.

Do I need any pre-flash of these modules, in addition to installing the switches before turning to the work?
(sos)
Can anybody share the following documentation:

CONTROLNET gateway Operating Instructions BA 181F/00/en
Gateway ZA 672 Operating Instructions BA 054F/00/en
Gateway ZA 672 Technical Information TI 148F/00/en
Commutec operating program Technical Information TI 113/00/en
Rackbus System Information SI 014F/00/e
Rackbus RS-485 Operating Instructions BA 134F/00/e
(oo)

Post Reply