Hello Guys,
I´m currently search the Programs DISOPLAN & DISOVIEW from SCHENCK PROCESS GmbH.
I Stuck in India for Calibration a Wight Table and without software quite difficulty to do because the Documentation CD is lost......
On the homepage of Schenck not possible to download
Can someone provide the programm. Thanks in Advance
[Request]: Schenck DISOPLAN & DISOVIEW
Re: [Request]: Schenck DISOPLAN & DISOVIEW
Hi,
probably to late..... but for thew next time....
Disoplan 9.0.6
https://mega.nz/file/83U2jDKa#WfmLXNOAt ... hKsBTR-fvY
Disoplan 11.0.14.1
https://mega.nz/file/kv80CDbb#m6bSPDDj5 ... jY6K5dcutk
Schenk CD
https://mega.nz/file/BqcBHLiD#GPw_n3_3o ... A1Cb4KKzLU
probably to late..... but for thew next time....
Disoplan 9.0.6
https://mega.nz/file/83U2jDKa#WfmLXNOAt ... hKsBTR-fvY
Disoplan 11.0.14.1
https://mega.nz/file/kv80CDbb#m6bSPDDj5 ... jY6K5dcutk
Schenk CD
https://mega.nz/file/BqcBHLiD#GPw_n3_3o ... A1Cb4KKzLU
Re: [Request]: Schenck DISOPLAN & DISOVIEW
Hello friends!
Please help me connect Disomat B plus to Disoplan
. I connected it to the Service connector and to both Rs232 via Com-port and via a Com-USB converter. I used a regular three-wire (Rx,Tx,Gnd) DB9-DB9 cable. Disoplan does not see the controller 
. What are the features when connecting? Do you need a special cable? What mode should Disomat B plus be in? Tell me where to look? 
Thank you!
Please help me connect Disomat B plus to Disoplan
. I connected it to the Service connector and to both Rs232 via Com-port and via a Com-USB converter. I used a regular three-wire (Rx,Tx,Gnd) DB9-DB9 cable. Disoplan does not see the controller . What are the features when connecting? Do you need a special cable? What mode should Disomat B plus be in? Tell me where to look? Thank you!