[?]: Stupid HMI Software for very small box-PC ?

NetMare · Post by **NetMare** » Fri Dec 05, 2008 11:51 am

Hey guys,

I'm searching for an stupid HMI Software (has to run on a very small box-PC) witch has an OPC Interface or somthing similar because I'm working with Profinet (S7 and WinCC) and Modbus over TCP/IP (Momentum from Telemechanique/Schneider).

I don't want to put any logic inside this HMI - its just to show some operating buttons and some feedbacks without scaling/calculations ect.

So I'm searching for some kind of HMI software that is somehow similar to a stupid termial...

Anyone got a hint for me to crack this case?

Greetz!

rack123 · Post by **rack123** » Fri Dec 05, 2008 5:19 pm

Hello,

take a look at this:

http://www.soft-control.fr/articles.php?id=25

It's very simple but nice, tested on serial modbus RTU and seem works fine.

Mini-Scada Pro is supplied free of charge for private non-commercial use.
Any commercial or professional use requires a registered copy of the software (registration with the author).

There are other interesting software in the download section of the link above.

NetMare · Post by **NetMare** » Mon Dec 08, 2008 11:33 am

Hey rack,

tnx for that link.
I'll take a closer look on that one!

Ceers!

Greetz