plcforum.uz.ua

International PLC Forum
It is currently Wed Jul 26, 2017 3:50 pm

All times are UTC + 3 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Oct 30, 2011 2:18 am 

Joined: Sat May 01, 2010 1:30 am
Posts: 24
hello everybody.

I am looking for this old software to program these olg message displays from cutler hammer. it is a ms-dos software ...
i think it´s called " Micro PanelMate Configuration Editor ". I can´t find it nowhere.
is there anybody that has got it?
I have some of this old message displays and i would like to make them useful.

here there´s some information about these displays....

http://www.eaton.com/ecm/groups/public/@pub/@electrical/documents/content/1063683030256.pdf
So, i´ll be thankful if someone could send it to me.

thanks in advance

from portugal

tintin2005


Top
 Profile  
 
PostPosted: Sun Apr 23, 2017 12:08 am 

Joined: Sat May 01, 2010 1:30 am
Posts: 24
Hello!

Anyone found the required software in the last post?

regards


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 3 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by International PLCforum® Forum Software © PLCforum
Mobile version