Hi All,
I am writing here in the hope that someone can help me with a problem I have with some Trend Controls' hardware; I have 4 IQ3Xcite/96/100-240 controllers and corresponding extensions modules; I have recovered them from an old experimental HVAC installation but they were almost new.
I have no documentation nor software about the original system.
I am guessing if it would be possible to reset these controllers to use them somewhere else.
Is here someone that has the basic configuration/programming software to recover this hardware.
From some documents I have found on the Trend Controls website, it seems that one of the basic utilities is the IP setup one.
Any hint will be greatly appreciated.
Thanks