E300 Run Mode

Прочие SCADA: iFix, InTouch, Citect, ...
Post Reply
mayorx
Posts: 3
Joined: Tue Oct 06, 2015 9:14 pm

E300 Run Mode

Post by mayorx » Wed Oct 28, 2015 8:24 am

HMI Can't start to RUN mode.
- - HMI after RS422 Chip replace - -
Question- what I should to do to go to RUN MODE
Image

Cable - original after
Ports - RS422 tested in E-Designer, possible to download the softfrom HMI
Communication settings
a) Port Parameters : RS422, 9600, 81EVEN


First communicat after start
Image

After ENTER
Image

After a few minutes
Image

PLC
Image

Post Reply