[+]: UniOP EKDR-16

[Ber56]

A question for experts HMI UniOP
I have an operator panel EKDR-16 UniOP.The panel has a port RJ-45 (Ethernet).How can I connect to the panel (What cable and software to use to get the project from the panel).I have't found any documentation (datasheets,manuals) for this panel, but there is a similar model BKDR-16
Thanks in advance.
//////////////////////////////////////////////////////////////////////
Special thanks to Google for their wonderful translator

[sercos]

You need Designer.

http://www.plcforum.uz.ua/viewtopic.php ... iop#p33357

Cable ;

Panel ( PC/Printer port ) -> PC ( Serial 9 pin )


2 -> 2
3 -> 3
5 -> 7
10 ( Bridge, panel side )
11