Request: Micro PanelMate Configuration Editor

Прочие SCADA: iFix, InTouch, Citect, ...
Post Reply
tintin2005
Posts: 25
Joined: Fri Apr 30, 2010 10:30 pm

Request: Micro PanelMate Configuration Editor

Post by tintin2005 » Sat Oct 29, 2011 11:18 pm

hello everybody.

I am looking for this old software to program these olg message displays from cutler hammer. it is a ms-dos software ...
i think it´s called " Micro PanelMate Configuration Editor ". I can´t find it nowhere.
is there anybody that has got it?
I have some of this old message displays and i would like to make them useful.

here there´s some information about these displays....

http://www.eaton.com/ecm/groups/public/ ... 030256.pdf
So, i´ll be thankful if someone could send it to me.

thanks in advance

from portugal

tintin2005

tintin2005
Posts: 25
Joined: Fri Apr 30, 2010 10:30 pm

Re: Request: Micro PanelMate Configuration Editor

Post by tintin2005 » Sat Apr 22, 2017 9:08 pm

Hello!

Anyone found the required software in the last post?

regards

jagmohan
Posts: 1
Joined: Sun Feb 17, 2013 11:03 pm

Re: Request: Micro PanelMate Configuration Editor

Post by jagmohan » Sun May 09, 2021 3:19 am

ANYONE HAS CUTLER HAMMER PANELMATE POWERPRO HMI SOFTWARE ?

Post Reply