[?]Autem PLC Analyzer 5 with SLC 500

kriztof · Post by **kriztof** » Sat May 10, 2008 12:40 pm

Hi
I configured PLC Analyzer 5 to collect data from digital outputs but when i run program in CPU and start acquisition process, signal states don't change in graph window. Serial driver works with no errors.
I noticed that program converts AB addresses to different syntax e.g. when I type output word address O:8.0 then progrm converts this address to O:008 and bit addresses look like O:008.xx where xx is bit nubmer and these are not valid values in RSLogix . Anyone can help with that? Maybe someone has working project and could upload it?