Request: firmware upgrade PLC5/SLC500
-
- Posts: 66
- Joined: Sat Mar 10, 2007 8:11 am
- Location: Spain
Request: firmware upgrade PLC5/SLC500
Hello everybody.
Somebody have tool firmware upgrade for PLC5 and SLC500???
Thanks a lot.
Dr.Acrobat (no adobe)
Somebody have tool firmware upgrade for PLC5 and SLC500???
Thanks a lot.
Dr.Acrobat (no adobe)
-
- Posts: 66
- Joined: Sat Mar 10, 2007 8:11 am
- Location: Spain
Firmware tool
Sorry Seinfield,
but where can found it on Rockwell site???
Thank you.
but where can found it on Rockwell site???
Thank you.
-
- Posts: 66
- Joined: Sat Mar 10, 2007 8:11 am
- Location: Spain
AB???
Sorry Seinfield,
but I don't found it.
The package for firmware upgrade I be found is just for Control Logix 5000 and not for PLC5 and SLC500.
Do you write please correct URL???
Thanks.
Regards.
but I don't found it.
The package for firmware upgrade I be found is just for Control Logix 5000 and not for PLC5 and SLC500.
Do you write please correct URL???
Thanks.
Regards.
Sorry, the updates is only for Controllogix.
But i founded that:
For PLC5, you need to ask the nearest AB store for that updates.
For SLC500 the same.
http://www.rockwellautomation.com.ve/ap ... nes_-_2003
But i founded that:
For PLC5, you need to ask the nearest AB store for that updates.
For SLC500 the same.
http://www.rockwellautomation.com.ve/ap ... nes_-_2003
In the past when we've had firmware issues and we've contacted AB; they've
always sent one of their service techs to do the firmware upgrades. The reason being, if something goes wrong, they take full responsibility for the replacement of the PLC (they will give you a refurbished one if the upgrade fails). I'm not sure if its worth the risk to try and do this yourself, especially if
the PLC is part of a critical machine.
Best of Luck.
always sent one of their service techs to do the firmware upgrades. The reason being, if something goes wrong, they take full responsibility for the replacement of the PLC (they will give you a refurbished one if the upgrade fails). I'm not sure if its worth the risk to try and do this yourself, especially if
the PLC is part of a critical machine.
Best of Luck.