plcforum.uz.ua

International PLC Forum
It is currently Wed Jun 20, 2018 7:02 am

All times are UTC + 3 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Mar 07, 2018 4:43 am 

Joined: Thu Mar 06, 2014 7:20 am
Posts: 15
Hello,

I have a cut to length application, and i want to use Contrologix V21.11
CPU 1756-L71 together with 1756-HSC/B counter module to make this
application.

There will be a measuring wheels place directly above the material to detect the length of material pass thru
and also the line speed.
The measuring wheels is driving a encoder over a gear ratio of 20/6 to increase the encoder pulses.
That mean, 6 turns at measuring wheels will give us 20 turns at the encoder.

The encoder is having a 16384pulses/rev. In quad mode, we will have 65536pulses/rev from the encoder.

The measuring wheels diameter is 200mm, which mean circumference will be 628.3185mm.
That means, 628.3185mm=21854.3333 pulses (Result of 65536pulses x 20/6).

Counter 0 of 1756-HSC will be configure to Encoder x 4 to measure the material length. Roll Over=16123456.
Max measurable encoder revolutions=16123456/21854.333=737 revolutions. 737 revolutions at encoder mean 737x6/20=221 revolutions at measuring wheels. 221x628.3185mm=139066mm or 139.066m.

Counter 1 of 1756-HSC will be configure to Freq Mode to measure the material speed.

As the material flow continuously, the counter will roll over to 0 at every 139.066m.

How can i have the Output 0 of the 1756-HSC to turn ON for 100ms only when the length reached 4920mm, and at the same time, Output 1 turn ON for 100ms only when length reached 5000mm.

Mean output 0 will turn a precisely (tolerance of 1.5mm allow) at 4920mm,9840mm, 14760mm, 19680mm........132840mm,137760mm..(142680mm is not possible, counter 0 already Roll over to zero)...

And output 1 will turn a precisely (tolerance of 1.5mm allow) at 5000mm,10000mm, 15000mm, 20000mm........130000mm,135000mm..(140000mm is not possible, counter 0 already Roll over to zero)...

How to solve this application with Contrologix ?

Any programming example and advice is very much appreciated.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 3 hours


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by International PLCforum® Forum Software © PLCforum
Mobile version