plcforum.uz.ua
http://plcforum.uz.ua/

can't view or save the program
http://plcforum.uz.ua/viewtopic.php?f=12&t=25700
Page 1 of 1

Author:  kevinCN [ Wed Dec 13, 2017 11:55 am ]
Post subject:  can't view or save the program

i cannot upload or modify at rslogix 500 due to s:1/14 access deny bit is active´╝îat the same time,data table protection was enable,in this case,how to upload the plc program

Author:  psgama [ Sat Dec 16, 2017 1:24 am ]
Post subject:  Re: can't view or save the program

What version RSlogix 500 you use?

Author:  kevinCN [ Sat Dec 16, 2017 3:05 am ]
Post subject:  Re: can't view or save the program

psgama wrote:
What version RSlogix 500 you use?


the version rslogix 500 is v10,thiank you

Page 1 of 1 All times are UTC + 3 hours
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/