Page 1 of 1

can't view or save the program

Posted: Wed Dec 13, 2017 8:55 am
by kevinCN
i cannot upload or modify at rslogix 500 due to s:1/14 access deny bit is active,at the same time,data table protection was enable,in this case,how to upload the plc program

Re: can't view or save the program

Posted: Fri Dec 15, 2017 10:24 pm
by psgama
What version RSlogix 500 you use?

Re: can't view or save the program

Posted: Sat Dec 16, 2017 12:05 am
by kevinCN
psgama wrote:What version RSlogix 500 you use?
the version rslogix 500 is v10,thiank you

Re: can't view or save the program

Posted: Fri Feb 02, 2024 7:55 am
by Kh_444
Can you send me the program file please?