FactoryTalk View Studio ME (9.00) ERROR THAT I CAN'T FIGURE.
Posted: Sat Nov 05, 2016 1:39 pm
Folks,
I've not had this problem before and it is likely something stupid that I did to cause this...
Below is the error message I get when I try to create a runtime application (.MER) for my PV Plus 7 Standard (Using firmware 7)
__________________________________________________ _____________
*** Start RSLinx Enterprise Conversion Messages ***
ERROR: Unsupported driver detected. Driver name = "RSLogix 5000 Emulator". Description:
Only the Ethernet driver is supported by PanelView Plus 7 Standard Machine Edition applications. Only the Ethernet,
Serial DF1 and Serial DH485 drivers are supported by Compact Machine Edition applications.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with errors. The runtime application has NOT been created.
__________________________________________________ _____________
I haven't had this happen before; I was trying to setup the emulator awhile back so I could run in design time from my desk, but I don't know what to do or how solve this problem...
Hope you can help...
Thanks so much in advance...
John Whited
I've not had this problem before and it is likely something stupid that I did to cause this...
Below is the error message I get when I try to create a runtime application (.MER) for my PV Plus 7 Standard (Using firmware 7)
__________________________________________________ _____________
*** Start RSLinx Enterprise Conversion Messages ***
ERROR: Unsupported driver detected. Driver name = "RSLogix 5000 Emulator". Description:
Only the Ethernet driver is supported by PanelView Plus 7 Standard Machine Edition applications. Only the Ethernet,
Serial DF1 and Serial DH485 drivers are supported by Compact Machine Edition applications.
*** End RSLinx Enterprise Conversion Messages ***
Validation completed with errors. The runtime application has NOT been created.
__________________________________________________ _____________
I haven't had this happen before; I was trying to setup the emulator awhile back so I could run in design time from my desk, but I don't know what to do or how solve this problem...
Hope you can help...
Thanks so much in advance...
John Whited