plcforum.uz.ua

International PLC Forum
It is currently Mon Dec 10, 2018 9:54 am

All times are UTC + 3 hours




Post new topic Reply to topic  [ 5 posts ] 
Author Message
PostPosted: Mon Feb 08, 2016 1:54 pm 

Joined: Mon Feb 08, 2016 12:00 pm
Posts: 3
I was dealing with micrologix 1500 without any problem except the battery. I change the battery after awhile but I receive this error message form the system :
No response from processor at selected path/ node...diagnosticstatus failed 0x10
has any body faced this problem ?
I searched in rockwell automation site for the remedy and it says that you should upgrade your RSlogix 500 software up to 7.10.
has any body has the rslogix 500 v7.10 and related rslinx software (I mean the cracked one ) .
I appreciate any other solution for the problem as well.


Top
 Profile  
 
PostPosted: Mon Feb 08, 2016 11:18 pm 

Joined: Wed Apr 30, 2014 9:16 pm
Posts: 81
Try again starting RSLogix 500 while holding the CTRL+Shift buttons.


Top
 Profile  
 
PostPosted: Tue Feb 09, 2016 11:46 am 

Joined: Mon Feb 08, 2016 12:00 pm
Posts: 3
NowanH wrote:
Try again starting RSLogix 500 while holding the CTRL+Shift buttons.


I am dealing with SLC500 with this software at the same time and without any problem, what happen if I hold CTRL+Shift at RS-Logix Start up ?


Top
 Profile  
 
PostPosted: Sun Feb 21, 2016 11:40 pm 

Joined: Thu Aug 08, 2013 9:00 pm
Posts: 78
How are you attempting to connect? Ethernet or RS-232?


Top
 Profile  
 
PostPosted: Sat Apr 16, 2016 3:24 pm 

Joined: Mon Feb 08, 2016 12:00 pm
Posts: 3
psgama wrote:
How are you attempting to connect? Ethernet or RS-232?

I am trying to connect to a Micrologix 1500 through a 1761-NET-ENI and cannot get connected, this is just to put it on plant network so I can connect with RSLinx from my desk. I can see the NET-ENI in Linx but in Idle mode, but when I try to connect I get diagnosticstatus 0x10 error. I used to connect to it before battery failure, after that I could not connect. I even changed my 1764-LSP(Micrologix CPU) and Upgrade my Rs-logix 500 software to 8.1 but did not solve the problem.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 5 posts ] 

All times are UTC + 3 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by International PLCforum® Forum Software © PLCforum
Mobile version