plcforum.uz.ua

International PLC Forum
It is currently Fri Dec 14, 2018 1:17 pm

All times are UTC + 3 hours


Forum rules


Please click here to view the forum rules



Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: Tue Aug 28, 2018 6:09 pm 

Joined: Wed Aug 08, 2018 9:18 pm
Posts: 4
Hello everyone;
First of all, I am a beginner in the OMRON PLC and I am carrying out a balance of 300 kg for mill machine.
The attached figure describes the system, initially the balance is empty, the motor M1 starts up to a value of 60 kg then stop.
Then the motor M2 starts up to a value of 100 kg and the same thing for the motor M3, and the M4 motor (40kg).
after a measurement of 300 kg all the motors are stopped, and the OUTPUT1 will open.
the used PLC is CJ2M
Please help how can I programming this balance, and if there is anything to add please tell me.

Image


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC + 3 hours


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by International PLCforum® Forum Software © PLCforum
Mobile version