Display I/O bits from ECAT Coupler on HMI (NB Designer)
Posted: Thu Aug 23, 2018 11:57 am
I have problem to display I/O signals from my ECAT coupler (Connected with PLC Omron NJ serie) on the HMI (Omron NB7W-TW01B).
When I make memory byte (%W...) in PLC and make logic for assignment of state no problem to display variables type W.
How is defined adress od Coupler modules? How to call it from NB Designer?
I was looking manuals but all shows only with with %W..
I am using NJ PLC with Sysmac V1.22 and NB Dewsigner V1.45.
Thank you in advance
When I make memory byte (%W...) in PLC and make logic for assignment of state no problem to display variables type W.
How is defined adress od Coupler modules? How to call it from NB Designer?
I was looking manuals but all shows only with with %W..
I am using NJ PLC with Sysmac V1.22 and NB Dewsigner V1.45.
Thank you in advance