Display I/O bits from ECAT Coupler on HMI (NB Designer)

CX-One, CX programmer, NTST, Syswin ....
Post Reply
milosrosic
Posts: 3
Joined: Fri May 25, 2018 5:20 am

Display I/O bits from ECAT Coupler on HMI (NB Designer)

Post by milosrosic » Thu Aug 23, 2018 11:57 am

I have problem to display I/O signals from my ECAT coupler (Connected with PLC Omron NJ serie) on the HMI (Omron NB7W-TW01B).
When I make memory byte (%W...) in PLC and make logic for assignment of state no problem to display variables type W.
How is defined adress od Coupler modules? How to call it from NB Designer?

I was looking manuals but all shows only with with %W..

I am using NJ PLC with Sysmac V1.22 and NB Dewsigner V1.45.

Thank you in advance

Post Reply